Heating and Cooling Tune-ups

 

Call 563-341-7577
To schedule your improved comfort levels today.

 

Summer Inspection:

  • Inspect condenser coil. (*Additional charge if cleaned)

  • Inspect condenser fan blade.

  • Inspect electrical connections and components.

  • Measure condenser fan motor amperage.

  • Measure compressor motor amperage.

  • Measure line side voltage on contactor.

  • Measure load side voltage on contactor.

  • Inspect metering device.

  • Measure super heat temperature if applicable.

  • Measure subcooling temperature if applicable.

  • Check for leaks if low on refrigerant charge.

  • Visually inspect all exposed ductwork.

  • Measure static pressure at the plenum, diffusers, grilles, and registers. 

  • Perform repairs on ductwork if applicable.

  • Clean diffusers, grilles, and registers.

  • Inspect the inside of the ductwork for debris.

  • Clean or replace air filters. (*Additional charge if replaced)

  • Inspect and clean evaporator coil if necessary.

  • Inspect and clean blower wheel. 

  • Inspect blower wheel belt if applicable.

  • Inspect motor mounts.

  • Measure blower motor amperage

  • Measure Delta T (air temperature drop) across evaporator coil.

  • Clean condensate lines and traps if applicable.

  • Veriify condensate pump operation if applicable.

 
Winter Inspection:

  • Measure line voltage coming into unit.

  • Inspect gas piping for leaks.

  • Verify type of heating system.

  • Inspect pressure switch operation.

  • Inspect flame sensor.

  • Inspect hot surface ignitor.

  • Inspect transformer.

  • Inspect thermostat.

  • Inspect Integrated furnace control.

  • Replace or clean air filter. *(Additional charge if replaced)

  • Inspect burner assembly.

  • Inspect heat exchanger.

  • Inspect combustion blower wheel.

  • Inspect pressure switch tubing.

  • Inspect blower wheel.

  • Oil motor if applicable.

  • Check motor mounts.

  • Clean condensate lines and traps if applicable.

  • Verify condensate pump operation if applicable.

  • Verify proper fuel input.

  • Inspect burner flame appearance.

  • Verify operation of the furnace high limit switch.

  • Measure the Delta T or temperature rise across the heat exchanger.

  • Set the blower delay if applicable.

  • Inspect the vent or flue pipe as well as the chimney.

 
​Additional Hot Water Boiler Inspections:
  • Inpect piping joints, components and valves for leaks.
  • Test high limit (Aquastat).
  • Check Air Pressure in Expansion Tank.
  • Inspect the boiler relief valve.
  • Check operation of pressure reducing valve.
  • Oil motor and pump bearings if applicable.

*$79 for Summer Cooling Inspection and *$79 for a Winter Inspection. A detailed and written checklist will accompany any inspection and/or recommendation. All services will be performed by a licensed HVAC company that is insured and bonded for your protection. Call Today for Your Free Estimate or Thorough Inspection.

*(Promotional Rates)

WARRANTY

We Guarantee our Work and Your Satisfaction. All labor / work is warrantied for 1 year after a new installation. All repairs have a 90-day warranty. A warranty is only as good as the people that stand behind it. And Wilson's HVAC & More is prepared to stand behind all its workmanship and equipment within the structure of all expressed warranties.